controlled by microprocessor 2/3/8 stage charging selectable on output panel (note 4) universal ac input / full range built-in active pfc function pf>0.95 protection: reverse polarity / short circuit / over voltage / over temper ature charger for lead-acid batteries 3 color led loading indicator 2-bank charger temperature compensation function fan on/off control (depends on charging current) 3 years warranty built-in remote on-off control features : specification pb-1000-12 pb-1000-24 pb-1000-48 model boost charge voltage float charge voltage battery type leakage current from battery (typ.) recommended battery capacity(amp hours) (note 3) output voltage range frequency range efficiency (typ.) power factor (typ.) input environment inrush current (typ.) leakage current over temperature short circuit reverse polarity safety standards harmonic current emi conduction & radiation safety & ems immunity emc (note 2) withstand voltage isolation resistance working temp. working humidity storage temp., humidity temp. coefficient vibration over voltage protection ac current (typ.) 14.4v 28.8v 57.6v 13.8v open & sealed lead acid <1ma 200 ~ 600ah 27.6v 55.2v 34.7a 17.4a 120 ~ 350ah 60 ~ 175ah 90 ~ 264vac 127 ~ 370vdc 47 ~ 63hz 85% 0.95/230vac 0.98/115vac at full load 88% 89% 12a/115vac 5.2a/230vac 25a/115vac 50a/230vac <3.5ma / 240vac 16 ~ 18v 32 ~ 35v 64.5 ~ 69.5v protection type : shut down o/p voltage, re-power on to recover 80 5 (12v), 85 5 (24v,48v) (tsw1: detect on heatsink of power transisto r) 85 5 (12v),75 5 (24v,48v) (tsw2 : detect on heatsink of o/p diode) protection type : shut down o/p voltage, recovers automatically after t emperature goes down yes, protected by internal circuit yes, protected by internal circuit ul60950-1, tuv en60950-1 approved compliance to en55022 (cispr22) compliance to en61000-3-2,-3 compliance to en61000-4-2,3,4,5,6,8,11; env50204, en55024, li ght industry level, criteria a i/p-o/p:3kvac i/p-fg:1.5kvac o/p-fg:0.5kvac i/p-o/p, i/p-fg, o/p-fg:100m ohms / 500vdc / 25 / 70% rh -20 ~ +60 (refer to output load derating curve) 20 ~ 90% rh non-condensing -40 ~ +85 , 10 ~ 95% rh 0.05%/ (0 ~ 50 ) 10 ~ 500hz, 2g 10min./1cycle, 60min. each along x, y, z axes mtbf 127.4khrs min. mil-hdbk-217f (25 ) 300*184*70mm(l*w*h) dimension others note packing 3.5kg; 4pcs/15kg/1.83cuft 1. all parameters not specially mentioned are measured at 230vac input, r ated load and 25 of ambient temperature. 2. the power supply is considered a component which will be installed into a fi nal equipment. the final equipment must be re-confirmed that it still mee ts emc directives. 3. this is mean well's suggested range. please consult your battery manuf acturer for their suggestions about maximum charging current limita tion. 4. please choose the "3 stage" selection when the charger is used to charge th e batteries and power the loads in the same time. pb-1000 series 1000w intelligent single output battery charger function remote control batter banks fast charge output ok temperature compensation charger ok open: normal work short: stop charging 2 banks (a & b) 2 / 3 / 8 stage selectable relay contact rating(max.): 30v/1a resistive ; "short" when the batt ery is full, "open" when the battery is still charging relay contact rating(max.): 30v/1a resistive ; "short" when the unit i s working properly, "open"when the unit is failure or the protection func tion is activating by ntc, compensate both banks at the same time file name:pb-1000-spec 2011-01-18 .. output current 60a
mechanical specification file name:pb-1000-spec 2011-01-18 case no. 804b unit:mm charging curve charge current constant current stage 1 stage 2 battery full constant voltage start 2 stage charge voltage 100% 10% boost v pin no. pin no. 5,6 7 9 10 3,4 ry13 : bank a ok ntc / gnd : temperature sense ry14 : bank b ok ry15 : charger ok rc+ / rc-: remote on/off 1,2 8 assignment assignment ry15 gnd ry14 ry13 mating housing terminal or equivalent or equivalent control pin no. assignment(cn100) : hrs df11-10dp-2ds or equivale nt hrs df11-10ds hrs df11-**sc rc- rc+ ntc(5k ) air flow direction ac input inlet on off 72.6 10 155 7 300 70 a 48 26.5 a 70 22 22 184 switch on/off a b a b 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 1 1 0 0 stage 8/3/2 stage 8/3/2 orange green color of led charge current constant current stage 1 stage 2 stage 3 constant voltage float start 3 stage charge voltage 100% 10% boost float vv orange green color of led pb-1000 series 1000w intelligent single output battery charger
file name:pb-1000-spec 2011-01-18 8 stage pb-1000 series block diagram control control detection detection switching power active inrush current limiting rectifier & pfc pfc control aux power mcu fan otp pwm remote bank a ok bank b ok charger ok reverse current filter & rectifier bank a (+v) bank b (+v) 2/8 stage select rc ry13 ry14 ry15 i/p filter emi pfc : 95khz pwm fosc : 60khz 1000w intelligent single output battery charger the function of leds battery color of led fail charging battery full red orange green derating curve ambient temperature ( ) load (%) 20 40 60 80 100 -20 0 10 20 30 40 50 60 70 (horizontal) charge current stage 1 stage 2 stage 3 stage 4 stage 5 stage 6 stage 7 stage 8 charge voltage pulse soft start constant current constant voltage analysis recondition float maintain orange green color of led
between rc+(pin10) and rc-(pin9) sw open sw short charger on off the charger can be turned on/off by using the the charger may be hooked up two battery banks (a and/or b). connect the batte ry bank(s) as below. if you are connecting 2 battery banks in the same time, keep in mind that they must share a common ground. "remote control" function. sw 9 10 cn100 ry13 ry14 ry15 gnd rc- ry13 ry14 ry15 rth rc+ 1 2 file name:pb-1000-spec 2011-01-18 pb-1000 series function manual 1.remote control 2.two battery banks a a a b b b stage 8/3/2 stage 8/3/2 stage 8/3/2 + + + + battery a battery b battery a battery b - - - - a b stage 8/3/2 + + battery a battery b - - 1000w intelligent single output battery charger a a a a b b b b 1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5 6 6 6 6 7 7 7 7 8 8 8 8 9 9 9 9 1 1 1 1 0 0 0 0 function description of cn100 pin no. function description 1,2 3,4 5,6 7,8 9,10 ry13 relay contact rating(max.) : 30v/1a resistive. ; "short" when the batt ery a is full, "open" when the battery a is still charging. relay contact rating(max.) : 30v/1a resistive. ; "short" when the batt ery b is full, "open" when the battery b is still charging. relay contact rating(max.) : 30v/1a resistive. ; "short" when the unit i s working properly, "open" when the unit is failure or temperature sensor comes along with the charger can be connected to the uni t to allow temperature compensation of the turn the output on and off by electrical or dry contact between pin 10 (rc+) and pi n 9(rc-), "open" : normal work , "short" : stop charging the protection function is activating. charging voltage. if the temperature sensor is not used, the charger still works normally. ry14 ry15 gnd / rth rc- / rc+
switch right middle left charging mode 2 stage charging 3 stage charging 8 stage charging (1)the charger features user selectable 2,3, or 8 stage charging. the charging profile is selected by moving the slide switch on the back panel. 3. 2,3, or 8 stage charging select charger bank a bank b 1.bank a ok (ry13) 2.bank b ok (ry14) normal work failure or the protection function is activating between pin5 and pin6(ry15) between pin1 and pin2(ry13) color of led a color of led b between pin3 and pin4(ry14) on (short) on (short) green green on (short) off (open) off (open) orange orange off (open) 4.charger ok relay(ry15) 5.output ok relay(ry13 & ry14) 99 9 10 10 10 cn100 cn100 cn100 ry13 ry13 ry13 ry14 ry14 ry14 ry15 ry15 ry15 gnd gnd gnd rc- rc- rc- ry13 ry13 ry13 ry14 ry14 ry14 ry15 ry15 ry15 ry14 ry13 ry15 rth rth rth rc+ rc+ rc+ 11 1 22 2 (2)please choose the "3 stage" selection when the charger is used to charge the batteries and power the loads in the same time. file name:pb-1000-spec 2011-01-18 pb-1000 series a b stage 8/3/2stage 8/3/2 stage 8/3/2stage 8/3/2 + + battery a battery b - - a b + + battery a battery b - - a b + + battery a battery b - - a b + + battery a battery b - - temperature sensor comes along with the charger can 6.temperature compensation be connected to the unit to allow temperature compensation of the charging voltage. if the temperature sensor is not used, the charger still works normally. cn100 ntc the temperature sensor can either be attached to the battery or placed in its surrounding environment. ry13 ry14 ry15 gnd rc- ry13 ry14 ry15 rth rc+ 1 2 9 10 battery a full charging battery b full charging 1000w intelligent single output battery charger a a a a b b b b 1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4 5 5 5 5 6 6 6 6 7 7 7 7 8 8 8 8 9 9 9 9 1 1 1 1 0 0 0 0 stage 8/3/2
|
